{"id":9664,"date":"2017-06-11T23:57:40","date_gmt":"2017-06-11T23:57:40","guid":{"rendered":"http:\/\/mazdaman.x10host.com\/sm353337\/"},"modified":"2017-06-11T23:57:40","modified_gmt":"2017-06-11T23:57:40","slug":"sm353337","status":"publish","type":"page","link":"https:\/\/chroot-me.in\/16ND\/sm353337\/","title":{"rendered":"CLIMATE CONTROL UNIT INSPECTION [FULL-AUTO AIR CONDITIONER]"},"content":{"rendered":"
\n <\/p>\n
\n
\n
\n < Previous<\/a> Next ><\/a><\/p>\n

2016 – MX-5 – HVAC<\/h2>\n

<\/a><\/p>\n

CLIMATE CONTROL UNIT INSPECTION [FULL-AUTO AIR CONDITIONER]<\/h3>\n

1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION\/CONNECTION<\/a>.)<\/p>\n

2. Remove the following parts:<\/p>\n

a. Selector lever knob (AT) (See AUTOMATIC TRANSMISSION SHIFT MECHANISM REMOVAL\/INSTALLATION<\/a>.)<\/p>\n

b. Shift lever knob (MT)<\/p>\n

c. Shift panel component (See SHIFT PANEL REMOVAL\/INSTALLATION<\/a>.)<\/p>\n

d. Upper panel (See UPPER PANEL REMOVAL\/INSTALLATION<\/a>.)<\/p>\n

e. Parking brake lever boot panel (See PARKING BRAKE LEVER BOOT PANEL REMOVAL\/INSTALLATION<\/a>.)<\/p>\n

f. Rear console (See REAR CONSOLE REMOVAL\/INSTALLATION<\/a>.)<\/p>\n

g. Front console panel (See FRONT CONSOLE PANEL REMOVAL\/INSTALLATION<\/a>.)<\/p>\n

h. Front console component (See FRONT CONSOLE REMOVAL\/INSTALLATION<\/a>.)<\/p>\n

i. Scuff plate (See SCUFF PLATE REMOVAL\/INSTALLATION<\/a>.)<\/p>\n

j. Front side trim (See FRONT SIDE TRIM REMOVAL\/INSTALLATION<\/a>.)<\/p>\n

k. A-pillar trim (See A-PILLAR TRIM REMOVAL\/INSTALLATION<\/a>.)<\/p>\n

l. Hood release lever (See HOOD RELEASE LEVER AND RELEASE CABLE REMOVAL\/INSTALLATION<\/a>.)<\/p>\n

m. Driver-side lower panel (See DRIVER-SIDE LOWER PANEL REMOVAL\/INSTALLATION<\/a>.)<\/p>\n

n. Passenger-side lower panel (See PASSENGER-SIDE LOWER PANEL REMOVAL\/INSTALLATION<\/a>.)<\/p>\n

o. Center panel No.1 (See CENTER PANEL No.1 REMOVAL\/INSTALLATION<\/a>.)<\/p>\n

3. Remove the climate control unit with the connector connected. (See CLIMATE CONTROL UNIT REMOVAL\/INSTALLATION [FULL-AUTO AIR CONDITIONER]<\/a>.)<\/p>\n

4. Connect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION\/CONNECTION<\/a>.)<\/p>\n

5. Switch the ignition ON (engine off or on).<\/p>\n

6. Connect the negative (-) lead of the tester to body ground.<\/p>\n

7. Insert the positive (+) lead of the tester into each climate control unit terminal and measure the voltage according to the terminal voltage table.<\/p>\n