DTC C1031:35 [DSC HU/CM]

id040262906600

DTC	C1031:35	Tire Pressure Monitoring System (TPMS) set switch
DETECTION CONDITION		•  Continuous ON signal from the TPMS set switch for 60 s or more is detected
FAIL-SAFE FUNCTION		Refer to DTC TABLE. (See DTC TABLE [DSC HU/CM].)
POSSIBLE CAUSE		•  The TPMS set switch is pressed and held for 10 s or more •  TPMS set switch malfunction
SYSTEM WIRING DIAGRAM		—

Diagnostic Procedure

Step	Inspection		Action
1	VERIFY INSTRUMENT CLUSTER DTC •  Using the M-MDS, perform the instrument cluster DTC inspection. (See DTC INSPECTION [INSTRUMENT CLUSTER].) •  Are any DTCs present?	Yes	Go to applicable DTC inspection. (See DTC TABLE [INSTRUMENT CLUSTER].) DTC troubleshooting completed, then go to the next step.
		No	Go to the next step.
2	INSPECT TPMS SET SWITCH •  Inspect TPMS set switch. (See TIRE PRESSURE MONITORING SYSTEM SET SWITCH INSPECTION.) •  Is the TPMS set switch normal?	Yes	Go to the next step.
		No	Replace the TPMS set switch, then go to the next step. (See TIRE PRESSURE MONITORING SYSTEM SET SWITCH REMOVAL/INSTALLATION.)
3	VERIFY DTC TROUBLESHOOTING COMPLETED •  Reconnect all disconnected connectors •  Using the M-MDS, clear the DTC from the DSC HU/CM. (See CLEARING DTC [DSC HU/CM].) •  Using the M-MDS, perform the DSC HU/CM DTC inspection. (See DTC INSPECTION [DSC HU/CM].) •  Is the same DTC present?	Yes	Repeat the inspection from Step1 If the malfunction recurs, replace the DSC HU/CM, then go to the next step. (See DSC HU/CM REMOVAL/INSTALLATION [L.H.D.].) (See DSC HU/CM REMOVAL/INSTALLATION [R.H.D.].)
		No	Go to the next step.
4	VERIFY NO DTC IS PRESENT •  Are any DTCs present?	Yes	Go to applicable DTC inspection. (See DTC TABLE [DSC HU/CM].)
		No	DTC troubleshooting completed.