TWEETER INSPECTION

id092000808100

1.  Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION.)

2.  Remove the tweeter. (See TWEETER REMOVAL/INSTALLATION.)

Caution

•  Because the tweeter is built into the condenser, if the tester does not contact the measurement area shown in the figure, the correct resistance cannot be measured.

3.  Inspect the resistance between tweeter terminal A and the measurement area shown in the figure.

am2zzw00011641

•  If not within the specification, replace the tweeter. (See TWEETER REMOVAL/INSTALLATION.)